Plan Your Load

On this page you can enter multiples of different sizes to calculate a collective mass.
Please enter all relevant sizes in the blocks below and click the "Calculate" button near the bottom of the page to calculate the mass.
PLEASE NOTE: The weights given are for mild steel only.
Enter all values in mm.
Use the "Tab" key to navigate through the entry fields.

Enter the sizes of your Galvanised, Cold Rolled or Hot Rolled sheets below.

Picture of Sheets

Quantity Length Width Thickness Mass
1.  
2.  
3.  
4.  
5.  
Sheets:  

Enter the sizes of the square or rectangular tubes you require below:

Picture of Square Tubes

  Quantity Side A Side B Thickness Mass
1.  
2.  
3.  
4.  
5.  
Square and Rectangular Tubes:  

Enter the sizes of the Round tubes you require below:

Picture of Round Tubes

  Quantity Diameter Thickness Mass
1.  
2.  
3.  
4.  
5.  
Round Tubes:  

Enter the sizes of the solid square bar or flat bar you require below:

Picture of Square Bar

  Quantity Side A Side B Mass
1.  
2.  
3.  
4.  
5.  
Square Bar and Flat Bar  

Enter the sizes of the Round Bar and Reinforcing (Y) Bar you require below:

Picture of Reinforcing Roun Bar

  Quantity Diameter Mass
1.  
2.  
3.  
4.  
5.  
Round Bar:  

 


Click the button below to calculate the mass.
Sheets  
Square and Rectangular Tube  
Round Tube  
Square and Flat Bar  
Round and Re-Inforcing Bar  
 

 

These values are calculated using theoretical values only and should not be accepted as final.
They are merely intended to give a fairly accurate estimation of how much an order or load will weigh.

 


Aeroton Steel
2b Aerodrome Road
Aeroton
Johannesburg South
South Africa
Tel: 011 494 3666 │ email: aeroton@icon.co.za
Sheets and Plates
1.          
2.          
3.          
4.          
5.          
Sheets:  
Square and Rectangular Tubes
1.          
2.          
3.          
4.          
5.          
Square and Rectangular Tubes:  
Round Tubes
1.        
2.        
3.        
4.        
5.        
Round Tubes:  
Square and Flat Bar
1.        
2.        
3.        
4.        
5.        
Square Bar and Flat Bar:  
Round Bar
1.      
2.      
3.      
4.      
5.      
Round Bar and Y-bar:  
Grand Total
 

These values are calculated using theoretical values only and should not be accepted as final.
They are merely intended to give a fairly accurate estimation of how much an order or load will weigh.